#Silent clock mechanism michaels how to#
#Silent clock mechanism michaels install#
#Silent clock mechanism michaels upgrade#
#Silent clock mechanism michaels free#

A long shaft can always be shimmed down by using a pair of washers. Allow extra room to add a second hand or a cap nut on the minute hand. To use glass infront of your clock dial, there should be enough clearance here. For the total shaft length, measure from the movement housing to the tip of the shaft. A digital caliper or ruler can be used for this. The measurements needed are the overall length of the center hand shaft and threaded length. It is critical that you get the right size replacement/new clock movement that fits perfectly. However, you have to consider the factors below before you buy one. They will run quietly and keep accurate time. These non-ticking quartz movements can be used to repair and build clocks alike. Here the sweeping second hand will move silently around the clock dial. For the former, a continuous sweep clock mechanism has to be used.

#Silent clock mechanism michaels how to#

How to buy the Best Continuous Sweep Silent Clock MechanismĪ clock’s mechanism will determine whether it will run silently or with a clicking sound. Before you set the time, replace the battery on its slot.They should be parallel to each other and lined up at 12 o clock. This will secure the new silent running continuous sweep motor in place. Place a washer on the part that threads through.Now slide the movement shaft through the hole at the center of your clock case.Top it off with a rubber/plastic gasket so that it lies between the mechanism and the back of the clock.At this point, place the removable metal hanger(if any) on the shaft of your new silent clock movement.Sometimes the mechanism will be housed on the clock back so that it does not move around.

#Silent clock mechanism michaels free#

This will free the movement from the clock.

Use pliers to loosen the hex nut that sits between the clock face and hands.

If the clock hands are held on with friction, all of them can be pulled off with relative ease.

An old movement can only be released if you can access the clock’s hands. If spring clips have been used instead, remove them to get the clock out of the frame.

Unscrew the old mechanism from the dial face and take off the backpanel.

We have put together a step-by-step instruction guide below to help streamline this process.

#Silent clock mechanism michaels install#

Your new continuous sweep silent clock movement will render useless if you cannot install it.

#Silent clock mechanism michaels upgrade#

Now you can hang this silent upgrade too! How to replace and install a Continuous Sweep Silent Clock Mechanism During installation, dont forget to place the removable hook on the clock movement. Its very important you get these dimensions correct.

The American 'I' shaft configuration also requires a small round nut (included with movement purchase) to hold the minute hand in place.With a threaded length of 7/16 in, clocks no thicker than 0.25 inches will fit on the 3 / 4 inch long movement shaft. The American 'I' shaft configuration is used on most (but not all) battery and electric movements. The American 'I' shaft hand configuration is fairly easy to identify without measuring the mounting holes. On all American 'I' shaft movements, the mounting hole in the minute hand is 'oblong with two flat sides', and the hour hand hole is round. Choose hands here: įace thickness (this is how thick the material is that the hand shaft goes through) 3/4' One free pair with each movement you buy. Want free hands? Get free hour and minute hands (up to 5-1/4' long) with purchase of a quartz movement.

If you order a sweep hand we will send an open nut that will allow you to use all three hands. These movements can be used with or without a sweep second hand. We no longer include free hangers but you can order hangers separately. All of our quartz movements are shipped with mounting hardware. The threaded part of the hand shaft is 5/16' in diameter. They can use any of our quartz hands up to 5-1/2' long. They use one 'AA' battery (not included). These movements are 2-1/8' x 2-1/8' square and 5/8' deep.